You change the IP on the HMC, correct? Not within ASMI on the iSeries?
If that is the case, try setting a laptop with the old HMC IP address.
See if you can then connect to ASMI?
When you say nothing on the front panel, do you mean it is blank or no
SRC codes? What exactly does the front panel of the 520 have on it.
No there is no special processing that happens when you change the IP
address.
Chris Bipes
Director of Information Services
CrossCheck, Inc.
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jacob Anderson
Sent: Sunday, February 07, 2010 10:06 AM
To: midrange-l@xxxxxxxxxxxx
Subject: ASMI and changing IP address
Hello,
I have a 9405-520 with V6R1. Connected to the device using HMC1 and the
ASMI (
http://192.168.2.147). Followed the instructions to change eth0
to dynamic and eth1 to a static address, which apparently changed HMC1
and HMC2 (not expected).
Now the 520 isn't responding to neither the dynamic IP or the static IP
that I configured (not responding to ASMI load). I am able to ping both
IP addresses from the "console" computer. I am directly attached to HMC2
from the console computer, and connecting through the LAN switch for
HMC1.
I noticed the 520 was all of a sudden doing lots of activity - lots of
drive activity. This is a first-time access, so does the 520 do some
special setup operations when you first change the HMC IP addresses?
Nothing on the front panel either.
midrange.com
