× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. MIDRANGE-L
  3. September 2009

calling programs with parameters from the command line

To all



As you cal tell from this question I'm new to the 400/iSeries environment.



I want to call a program (pgm1) with one parameter (PRM01) from the command
line.

The parameter is 7,0 in the program and the value I want to pass is 87



I think the command line entry is:



Call pgm1 (0000087)



Obviously this is wrong because the program abends on a data error when I
use the above instruction format.



What should the command line entry look like?





Roy Luce

Systems Plus - Midwest



Direct: 847-540-9635

800-913-PLUS (7587)

Cell: 847-910-0884

Email: rluce@xxxxxxxxxxxxxxxxxxx




As an Amazon Associate we earn from qualifying purchases.

This thread ...
Follow-Ups:
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.