Re: Permanently Applying Firmware

[rob@xxxxxxxxx]

https://yourHmcNameHere
log in
Updates
Select server
View system information
None - Display current values
If "Accepted" level is not equal to Installed and Activated then you 
should "perm apply".  To do so...
Close the View window.
Change Licensed Internal Code for the current release 
Select Advanced Features (Not the Wizard)
Accept - Copy Temporary to Permanent
When you pass the readiness check press ok
Confirm, ok
I just did this on a system for you, with 3 lpars active and it was 
completely nondisruptive.  On that M25 I am now at 01EL320 level 83. 
Accepted level was lower than that until I went through this.  Based on 
another box on site I suspect it was at 01EL320 level 61.
 

Rob Berendt