×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
On Sun, Oct 5, 2008 at 7:33 AM, Pete Helgren <Pete@xxxxxxxxxx> wrote:
With multiple "layers" here, it is difficult to figure out what will
start by itself and what needs to be started and configured. The BCS
management console I can get to. It sees the blade. The blade is
started (it is powered on) but the next step is the tough one. Knowing
what address the IVM is on would be helpful.
Use SSH to connect to the AMM (The BladeCenter Management module which
you can also access over the web).
Then, type console -T blade[x], where x is the number of your JS12
blade in the chassis.
If VIOS is installed, this should give you a logon prompt, asking for
a username and password. Default username is padmin, but i'm not sure
i remember the default password - it's probably padmin too. Then, type
oem_setup_env, and then ifconfig -a to show the IP configuration of
VIOS. Use that IP to connect over the web, and you should see IVM.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
