Re: SBMRMTCMD Error

By any chance did STMDAILY in ACTOBJ get recompiled as ILE? That is, previously it may have been either OPM created by a CRTCLPGM or ILE but created with a different activation group than what it currently has? The return code 1254 is associated with token CMDCHKRM defined as "Command check reply message"; not very informative, except to a DDM architecture developer, I suppose. The request is also being run from\by ROBOT, so be sure to check for any changes there as well. Regardless, the errors indicate internal DDM errors and to perform service procedures; IIRC, both generally imply a probable defect.

Regards, Chuck

Bruce Collins wrote:

Do you guys know of some reasons that this SBMRMTCMD would just
start having issues. This is connect to a remote iSeries. Runs
the job and then should return. Below is the Joblog from the
Source System.


STMDAILY in ACTOBJ module STMDAILY proc STMDAILY stmt 13400
- SBMRMTCMD CMD('CALL (LAWAAA/LAWAPPLY)') DDMFILE(DBARABS)

<<SNIP>>
msgCPF9172 F/QCNSSCPP FM/QCNSSCPP FP/QCNSSCPP stmt/10658
T/STMDAILY TP/STMDAILY stmt/13400
"A distributed data management (DDM) error..."
"DDM data stream error code is x'1254" rcX1254 rc1254
<<SNIP>>

Here is the partial joblog from the Target System

<<SNIP>>
msgCPF9169 F/QCNTEDDM FM/QCNTEDDM FP/SNDMSG stmt/7919
T/QRWTSRVR TM/QRWTSRVR TP/main stmt/250
"Unexpected internal DDM error." "Start problem analysis (ANZPRB)"
<<SNIP>>