Brian,
<ShamelessSelfPromotion>
An alternative to IBM's provided program is the UPS Monitor Kit for iSeries,
by Attic Design Lab.
This kit provides source code with similar step by step instructions, with
the addition of logging of status messages to QHIST, and warnining messages
to all of the active workstation sessions on your system. This can be
compiled as is or customized for your unique requirements.
The direct ancestor of this program managed an extended power failure, and
powered down the system without data loss.
Available at www.atticdesignlab.com .
</ShamelessSelfPromotion>
Regards,
Armand Borick
"Eric Lehti" <elehti@xxxxxxxxxxxxxxxxxx> wrote in message
news:mailman.1240.1204760836.2436.midrange-l@xxxxxxxxxxxxxxx
Bryan, I recommend that you continue using the Powerware UPS with its
9-pin cable connected to your model 520. The advantage to you is that
when utility power fails, your System i will create the message to
QSYSOPR noting that fact. With that information, you can write a power
down CL program to do an orderly shutdown instead of risking a hard
shutdown when your 520 loses all power.
At our location, our emergency generators (fed by utility natural gas)
start up after five seconds off utility power outage ,and will run the
data center indefinitely.
.
Here is a link to IBM's document on writing a power-handling program.
http://tinyurl.com/28sk7b
http://publib.boulder.ibm.com/infocenter/iseries/v5r3/index.jsp?topic=/r
zahr/rzahrovrvwco.htm
Control server shutdown using a power-handling program
A power-handling power program, when used with power protection devices,
can minimize interruption during a power loss situation. Power
protection (for example, UPS) devices help provide energy to the system
when utility power is temporarily interrupted. The energy that is
provided helps prevent system functions from ending abnormally. The
controlled shutdown mechanisms help the system power down as smoothly as
possible, minimizing adverse impacts on re-IPL time.
The following steps can help you get started:
Enabling a power-handling program
Enabling a power-handling program to control system activity during a
power interruption is one way to power down as smoothly as possible.
Implementing a power-handling program
This example provides step-by-step instructions for you to use when
implementing a power-handling program on an iSeries server .
Writing a power-handling program
Writing a power handling program can help you handle a brief power
interruption without doing any unique processing or it can prepare for a
normal power down if power is not restored after a brief time period.
You can tailor the CL program examples to your specific system
requirements, as well as test the power-handling program that you
created.
midrange.com
