RE: SAVRSTLIB problem

Hello Trevor,

In my experience, one possible cause would be the QAPPNRMT configuration
list setting:

Change Configuration List
SYSTEMA
19-10-07
17:00:3
Configuration list . . : QAPPNRMT

Configuration list type : *APPNRMT

Text . . . . . . . . . : Remote location list



Type changes, press Enter.



----------------------------APPN Remote
Locations---------------------------
Remote Remote Control

Remote Network Local Control Point Location
Secure
Location ID Location Point Net ID Password Loc

SYSTEMB APPN SYSTEMA SYSTEMB APPN *YES


Did you configure your source system as a secure location in the
QAPPNRMT configuration list on the target system? If not, and you decide
to make the change, be sure to vary the APPC controller on the target
system off and on again after the change, for the new setting to take
effect.

Best regards,
Carsten Flensburg

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Trevor Perry
Sent: 19. oktober 2007 15:49
To: Midrange Systems Technical Discussion
Subject: SAVRSTLIB problem

I checked the archives, and there was no answer to help me, so here
goes...

I have a 520 and a 515. I have configured AnyNet and can STRPASTHR -
both
ways. I am attempting SAVRSTLIB from the 520 - pushing to the 515. I
have
checked my Communication Entries, and tested with the user as *NONE, as
QUSER (which I think was installed when ObjectConnect was installed),
and
also as *SYS.

Yet, I still get this error on the 520:
~~~~~~~~~~~~~~~~~~~~
Message . . . . : Communications failure. Session was not started.
Cause . . . . . : The system has detected a communications failure.
The
sense code is X'080F6051'.
~~~~~~~~~~~~~~~~~~~~

The SNA Formats manual tells me that 080F6051 is:
~~~~~~~~~~~~~~~~~~~~
Access Security Information Invalid: The request specifies an Access
Security Information field that is unacceptable to the receiver; for
security reasons, no further detail on the error is provided. This sense
data is sent in FMH-7 or UNBIND.
~~~~~~~~~~~~~~~~~~~~

On the 515, I am getting this error:
~~~~~~~~~~~~~~~~~~~~
Message ID . . . . . . : CPF1269 Severity . . . . . . . : 00
Message type . . . . . : Information
Date sent . . . . . . : 10/19/07 Time sent . . . . . . :
09:29:07

Message . . . . : Program start request received on communications
device
SYSTEM was rejected with reason codes 715, 0.
Cause . . . . . : The program start request was rejected in job
001111/QSYS/QCMN. The device belongs to remote location SYSTEM. If the
device is an advanced program-to-program communications (APPC) device,
the
program start request was received on mode QSOCCT with unit-of-work
identifier APPN.SYSTEM-C15E493CFBFB-0001. The first reason code means:
Neither password nor user ID was provided, and no default user profile
was
specified in the communications entry. The second reason code means:
None.
Recovery . . . : See the job log for more information about the
problem.
~~~~~~~~~~~~~~~~~~~~

I am using QSECOFR with the same pwd on both servers, so I have no
apparent
security issues. QRMTSIGN was tested with *SAMEPRF and *VERIFY for the
same
result.