RE: New version of HMC.

What are the firmware requirements. We upgraded to 6.1.2 last month
(were running 2 year old code) and my Server Firmware is at Level 96 (EC
01SF225).


Jeffry A. Kennedy
Certco,Inc
jkennedy@xxxxxxxxxxxxx
608-270-2385


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of
Tommy.Holden@xxxxxxxxxxxxxxxxxxxxx
Sent: Thursday, August 09, 2007 8:18 AM
To: Midrange Systems Technical Discussion
Subject: Re: New version of HMC.

thanks for the info Rob. hopefully i'll get to upgrade the HMC here.
it
hasn't been updated since 2005....new jobs are fun when nothing has been

PTFed, updated, etc for over 2 years....not.....

Thanks,
Tommy Holden



rob@xxxxxxxxx
Sent by: midrange-l-bounces@xxxxxxxxxxxx
08/09/2007 08:15 AM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>


To
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
cc

Subject
New version of HMC.






Loaded 7.3.1.0 of HMC (after getting my firmware up to an appropriate
level).
Loaded on MH01015, MH01030, MH01041 on the HMC.
The interface is very nice. Only those used to the old version, and
could

click on the right thing blindfolded, might complain.
Some small quirks like trying to start the 5250 session was a bit, well,

quirky, but I got it done.
Can't really duplicate the
ServerI
Partition1
Partition2
Partition3
ServerII
PartitionA
PartitionB
screen. I could get a group screen that listed
Partition1
Partition2
Partition3
PartitionA
PartitionB

Remote access to the HMC was incredibly easy to set up (once I found the

documentation). I went into: HMC Management, Administration, Remote
Operation and changed it from disabled to enabled. Then I used a
browser
to go to https://myhmc Remember, that is httpS, not just http. First
time I had to install a certificate. Now I get the full GUI easily.
Other

than installing the certificate (when prompted), and allowing popups for

this site, there was nothing to configure or install on the PC.

I don't have access to 5250 sessions started on the HMC via this method.
I

still had to use iSeries Access for Windows and change:
Communication, Configure, System Name
Communication, Configure, Properties, Use default User Id, prompt as
needed
Communication, Configure, Properties, User ID Q#HMC
Communication, Configure, Properties, Security, Not Secured
Communication, Configure, Type of emulation, Display, leave size at
24x80.
Communication, Configure, Port number, 2300, not the default of 23.
Make sure when you start 5250 sessions on the HMC you make them shared
and

not dedicated.

Rob Berendt