RE: Field filled in

In my example the user goes back to the same field and INSERTS extra text
into that field, pushing some pre-existing text to the right. Eventually
the right most character cannot go any further, but the cursor is NOT at
the right most character. Hence CHECK(ER) will NOT work (or at least it
doesn't on mine test sample)

Alan

midrange-l-bounces@xxxxxxxxxxxx wrote on 09/01/2006 03:03:33 PM:

Ok, then what do you want to do under what circumstances? The CHECK(ER)
would return to the program and you can check anything out that you want
about the last character, or ANY character.... ???

"is there a way for the program to realize that the last character is
NOT blank. "

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Alan Shore
Sent: Friday, September 01, 2006 2:03 PM
To: Midrange Systems Technical Discussion
Subject: RE: Field filled in

Thanks for your reply Dave. I think what you are talking about is
CHECK(ER).
I do use this, however if you re-read my example, the cursor is NOT at
the end of the field. That's my predicament.

Alan

midrange-l-bounces@xxxxxxxxxxxx wrote on 09/01/2006 02:27:16 PM:

Actually, there is a possibility of making the block oriented data
stream work something like what you want. It's been a long time, but
there is something you can put into DDS that tells the system to do an

auto-Enter type of action. If you were to put that on each field, as
the user went from field to field, the display would return to the

program.

You would then determine what field was entered, if it was correct or
not, and re-write the screen with the cursor placed where you wanted
it to be.

Don't know if it's practical, but I have used it in the past.
Primarily on the last record of a subfile used in heads down entry.
When the user hit the last field, the screen would automatically
refresh and the user would be able to continue entry with no
hesitation - OR - keying over information already entered...

Spoz that could stir up a bee's nest maybe... :-)

Dave

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing

list

To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.