RE: IFS share

Ah, didn't think of that.  No on the test system it is different.  I'll
change it on the test system and give it a retry.  

That makes perfect sense.. 

Michael Smith
iSeries.mySeries.


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Holder, Ken
Sent: Thursday, May 04, 2006 11:06 AM
To: Midrange Systems Technical Discussion
Subject: RE: IFS share



Is the user profile and password the same on the test system and the PC?
The PC will try to pass it's user profile and password first.  If that
fails it will then prompt for the user profile and password.  

If you want, setup a guest account in (if I remember) in iSeries
Netserver Properties, Security tab.  

Ken H.

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx]On Behalf Of Smith, Mike
Sent: Thursday, May 04, 2006 7:57 AM
To: midrange-l@xxxxxxxxxxxx
Subject: IFS share


I have a share set up on both our production system and our test system.

I'm trying to map a drive to both of these.  
So in DOS I run

Net use q: \\qry\shares$\testdir

If I do this on the production system the drive is mapped fine.  
If I do this on the test system, I get asked for a user and password.  
        It doesn't like my userid and password for the test system, but
I'm trying to figure out where I can turn this off.  

Michael Smith
iSeries.mySeries.