Bigger Font for OUTQ?

Our last "big honkin" twinax line printer will be going away shortly
(yea!!!).  As an alternative to the wide paper that the users are used to
for their reports I'm working on setting up a OUTQ for the 11x17 paper
drawer of their copier.  I've created the workstation customizing object
that selects the correct drawer and I've adjusted the PRTORIENT parameter
so that it it prints portrait on the paper.  The problem is that the font
is small and the output is squashed in the corner of the paper.

I seem to remember that you needed to remove the CPICOR lines to eliminate
the auto-reduction of the font.  I've done that but it doesn't look like it
did any good.  Even if it didn't auto-reduce it, I want to make it bigger.
Any suggestions?


Dave Parnin
--
Nishikawa Standard Company
Topeka, IN  46571
daparnin@xxxxxxxxxxxxxx