Are the mode descriptions that are being used the same on both systems?
> -------- Original Message --------
> Subject: Problem with connection between LPARS
> From: Pete Helgren <Pete@xxxxxxxxxx>
> Date: Fri, January 27, 2006 10:40 am
> To: Midrange Mailing List <MIDRANGE-L@xxxxxxxxxxxx>
>
> I have been trying to sort this one out. A customer had to rebuild an
> LPAR (saved the production partition "JCPS400A" and restored it as
> development "JCPSDEV"). That meant going through and changing some
> system settings so that we could get the communications between the
> LPAR's going again.
>
> Telnet works between systems (both ways). I can use STRPASTHR from the
> production side to the Dev side and I can use SAVRSTLIB from production
> to dev. The problem is that I can't use STRPASTHR from the dev side to
> the production side or SAVRSTLIB from dev to production.
>
> I looked at the APPC controller definitions and the communications
> entries and I am not seeing the problem.
>
> Job log shows the following on SAVRSTLIB:
> Ownership of object TXIDQ in QTEMP type *USRQ changed.
> Ownership of object RESPQ in QTEMP type *USRQ changed.
> APPC failure. Failure code is X'0009000000000000'.
> An error occurred during the SAVRSTLIB operation.
> An error occurred during the SAVRSTLIB operation.
>
> Job log shows the following on STRPASTHR:
> APPC failure. Failure code is X'68268004000032FE'
> APPC failure. Failure code is X'68268004000032FE'
>
> QSYSOPR shows:
>
> BIND sense code X'80040000' received for mode QSOCCT device JCPS400A
> Session maximum not established for mode QSOCCT device JCPS400A.
> All sessions ended for device JCPS400A.
> APPN session timed out following device selection.
>
> I looked up both APPC error codes and didn't get much helpful
> information. I am missing something simple, I am sure. Any guesses
> what the likely cuprit is?
>
> Thanks,
>
> Pete Helgren
>
> --
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
