RE: Connecting 3488 workstation -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

Griz,
Did you also set the workstations address? You have to set the following: 
controler, port & address.
Willie...

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx]On Behalf Of Grizzly M
Sent: Tuesday, November 08, 2005 11:24 AM
To: Midrange Systems Technical Discussion
Subject: Connecting 3488 workstation 

I'm trying to connect a 3488 InfoWindow II, but I am not having any
luck. I went into setup and selected the necessary port on the
controller that it is being connected to. I assumed that it would then
autoconfigure. It didn't. Assuming that the connection, controller, and
InfoWindow are working correctly should it autoconfig at this point? The
part that is really puzzling is the printer that is daisy chained on the
same cable autoconfigured right away at that port. I've tried 2
different 3488's and tried removing the printer. I still can't manage to
get a device created. Both of the InfoWindows were recently purchased,
so I would think that they in working order. Does anyone have suggestion
as to where I can begin troubleshooting? 

Thanks,

Griz

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.