Re: 7865-10 Modem

Jeff --

> I am trying to set it up for a vendor dial in in place on my ECS modem.
> It will let me have both lines active at the same time (separate
> software vendors).

I would start by reseting the modem to the Factory settings.
You have to use the buttons on the front of the modem to navigate through
the tree structure.  You didn't indicate whether sync or async
communications
were being done so I am asssuming sync since that is how use I this modem.

Press the left and right buttons together.
The display shows <Exit  Enter>
Press the right button.
The display shows View Only.
Press the down button until you see First Setup.
Press the right button.
Press the down button until you see Reset to Factory
Press the right button.
The display shows Profiles Only.
Press the right button again.  Display does not change.
Press the left button.  All lights should flash.
Continue to press left button to back out until display shows "Sync Int
9600 a"

On the iSeries, you now need a *LIND that is set up for *SLDC with the
autoanswer
parameter set to *YES.

----------------------
Scott

Scott A. Schollenberger
Chief Technology Officer
TENEX Systems, Inc.
2011 Renaissance Blvd., Suite 100
King of Prussia, PA  19406
Phone: 610-239-9988  Ext. 305
Fax: 610-239-9995
E-mail: saschollenberger@xxxxxxxxxxxx
Web: www.tenexsys.com

IBM Certified Specialist - eServer i5 iSeries Technical Solutions
Implementer V5R3

CONFIDENTIALITY NOTICE:  This email message, including any attachments, is
for the sole use of the intended recipient(s) and contains confidential and
privileged information.  Any unauthorized review, use, disclosure or
distribution is prohibited.  If you are not the intended recipient, please
contact the sender by reply email and destroy all copies of the original
message.

----------------------
"They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety."    --Benjamin Franklin
----------------------