RE: C.A. Question

You need to use RUNRMTCMD instead.  STRPCCMD, sends the requested command thru 
the 5250 session itself, so obviously it can't be used in batch.

You'll need the "iSeries Access Incoming Remote command" service, or another 
REXEC service running.

Also, may need to call the rtopcb in a batch file that first uses cwblogon to 
connect to the iSeries.  Additionally, if you are going to/from a network 
drive, you'll need to use the PC net commands to setup the network connection.


HTH,

Charles Wilt
iSeries Systems Administrator / Developer
Mitsubishi Electric Automotive America
ph: 513-573-4343
fax: 513-398-1121
 

> -----Original Message-----
> From: midrange-l-bounces@xxxxxxxxxxxx
> [mailto:midrange-l-bounces@xxxxxxxxxxxx]On Behalf Of Matthew Gross
> Sent: Tuesday, March 01, 2005 11:55 AM
> To: Post AS-400 System Questions
> Subject: C.A. Question
> 
> 
> The following works for file transfers interactively:
>  
>              STRPCO                                              
>              MONMSG CPF0000                                      
>                                                                  
>              STRPCCMD   PCCMD('c:\progra~1\ibm\client~1\rtopcb + 
>                           l:\otb\spdownload.dtf') PAUSE(*YES)    
>  
> Is there a corresponding command to run this xfer in batch?
>  
> TIA -
>  
> Matt
> -- 
> This is the Midrange Systems Technical Discussion 
> (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
> 
>