RE: iSeries Access Personal Communications Emulator Not Created U ser Job Logs when User Performs a Communication 'Disconnect'

Send a scope message in the users initial program for the job.  This will
cause the program in the scope message to run when the job ends.  I don't
know if you can run the signoff command in the scope program but you should
at least be able to print the joblog.

        -----Original Message-----
        From:   William N. Harrell, Jr. [SMTP:wharrell@xxxxxxxxx]
        Sent:   Sunday, November 02, 2003 6:13 AM
        To:     MIDRANGE-L
        Subject:        iSeries Access Personal Communications Emulator Not
Created User Job Logs when User Performs a Communication 'Disconnect'

        This is to follow up on my post yesterday on users performing
*Nolist
        Signoffs.

        We found the way this was being done was not from a command line
change of
        the Signoff Keyword List(*nolist), but instead, the user is just
doing the
        following in the iSeries Access Emulator:

        >From the iSeries Access Menu Bar:
        - select Communications, disconnect

        Then, the job log is not being created.

        Any ideas on how to force these to job logs ?




        _______________________________________________
        This is the Midrange Systems Technical Discussion (MIDRANGE-L)
mailing list
        To post a message email: MIDRANGE-L@xxxxxxxxxxxx
        To subscribe, unsubscribe, or change list options,
        visit: http://lists.midrange.com/mailman/listinfo/midrange-l
        or email: MIDRANGE-L-request@xxxxxxxxxxxx
        Before posting, please take a moment to review the archives
        at http://archive.midrange.com/midrange-l.