Release Ugrade to V5R1

Coming from V4R5M0, latest cum & group ptf's installed.

The Software Installation manual that came with the software has you load
the ptf's to upgrade to Ver.5.  The book talks about "structural changes for
future growth of object types" & then says "Then run the programs included
in the installation preparation PTF to estimate the amount of time needed
for these object conversions."

What programs are they talking about?  Looking through Information Center on
the web, it shows you the steps to load the ptf's & that's all.  I loaded
the ptf's & no messages were displayed.

Is this something I need to worry about although I would like to be aware if
the system seems to go out to never-never land, that this is how much time
would be involved?  Or is it located someplace else that I have not yet
found?

I sure don't like looking at two manuals for the installation, i.e. the
moving of Chapter 3 to the Information Center.

Thanks - Dennis.

Dennis Munro

"I love deadlines.  I especially like the whooshing sound they make as they
go flying by."  Dilbert's Words Of Wisdom:

Badger Mining Corporation
www.badgerminingcorp.com
dmunro@badgerminingcorp.com
(920) 361-2388