Re: Monitoring QHST

Hello Ted,

(Copied from my earlier reply to your direct e-mail)

The code I wrote does work for normal message queues.  I can't recall the
problem the original recipient had with it but I think it was
environmental.  You can test the code by running it from one interactive
session and send a message to QSYSOPR from another session and see if the
message appears at the bottom of the first session's display.

Note that it is example code and if you really care about certain messages
occurring you should do something other than resend as a status message --
paging someone or sending a break message to someone would be better --
status messages disappear in batch.

QHST is a special message queue and the system will not allow you to
display, or receive a message from QHST.  What messages were you
interested in monitoring?

Regards,
Simon Coulter.

--------------------------------------------------------------------
   FlyByNight Software         AS/400 Technical Specialists
   http://www.flybynight.com.au/

   Phone: +61 3 9419 0175   Mobile: +61 0411 091 400        /"\
   Fax:   +61 3 9419 0175   mailto: shc@flybynight.com.au   \ /
                                                             X
                 ASCII Ribbon campaign against HTML E-Mail  / \
--------------------------------------------------------------------