RE: Ops Nav & OS/400 v5r1 & SLIP Profile

I looked at InfoCenter and saw a reference to a manual migration from V4R5
SLIP to V5R1 in Ops Nav. Don't know details.

Did you go down into the config by pressing enter on the Properties for the
Connection Profile? The Connection tab there has a place to put the line
name, which would be the one that connects to your modem, right?

Haven't done thisyet. But was surprised that clicking OK brought up the
other PPP parameters.

At 01:53 PM 4/12/02 +0100, you wrote:
>... unfortunately it's not that, I have a full install, and I am signed on
>with a *SECOFR-type profile.
>
>Jeff Bull
>

-snip-

>[ Picked text/plain from multipart/alternative ]
>Hi all,
>
>I have just configured a couple of TCP PTP SLIP profiles on my iSeries;
>one
>has to use Ops Nav these days as the 5250 interface has had the function
>removed.  On the older versions of OS/400 the 5250 interface allowed you
>to
>attach a modem profile to the SLIP profile, in Ops Nav this ability
>appears
>to have been removed, though the ability to manage modem profiles is still
>present.
>
>When I start the SLIP profile it does not communicate correctly with the
>modem, the iSeries does not seem to use any of the modem command strings
>except AT.  It seems to me that I need to specify the correct modem for
>the
>SLIP session to use (US Robotics V90 FaxModem).
>
>Two possibilities occur to me:
>a)    The Ops Nav software is missing a 'service pack' - which I've looked
>for but not found;
>b)    The modem specification is hidden (in full view?) - which I've also
>looked for but cannot find.
>
>... any helpful suggestions will be gratefully received.
>
>Kind Regards
>
>Jeffrey E. Bull
>Software Support Consultant
>IBM Certified AS/400 System Administrator
>ITM Group Limited