RE: Display station connection question/issue?

Same here, I can switch everything from DSP02 to DSP03 and same issue.  No
matter what combo I use the PASS THRU station does not come on (DSP02 in
original config).  I seem to remember something about TERMINATION but like
you it's been too long.  Guess I am going to just make another run from that
room back to the 400 and skip the passthru for now.

-----Original Message-----
From: owner-midrange-l@midrange.com
[mailto:owner-midrange-l@midrange.com]On Behalf Of Bill Meecham
Sent: Wednesday, February 14, 2001 12:03 PM
To: MIDRANGE-L@midrange.com
Subject: Re: Display station connection question/issue?


Here's a guess, what does the wire look like?  It should be straight through
but if the wire is being reversed between the connectors, the signal is not
going through at the right point on the connector.  I forget the
nomenclature used with the types of wire but obviously not the twinaxial
type.  Can you try the wire that you have connecting DSP03 on DSP02?
Or...aren't there 3-4 and 2-5 baluns, try the opposite of what you have now
on DSP02?   Of course the pig-tail could be bad or a problem with the base
or the configuration of the terminal itself but it's been way too long to
remember without one in front of me.

Hope this helps.
Bill



----- Original Message -----
From: Mark Allen <mark.allen@fast-friends.com>
To: MIDRANGE-L <MIDRANGE-L@midrange.com>
Sent: Wednesday, February 14, 2001 10:58 AM
Subject: Display station connection question/issue?


> It's been a long time since I had to deal with this, so if someone can
> tell me what I am doing wrong I would greatly appreciate it.
>
>
> Configuration
>
>
> DSP01-----Twinax cable-----PRT01--Balun--network
> cable--Balun--DSP02--Balun--network cable--Balun--DSP03
>
>
> What happens is that DSP03 gets a signon but DSP02 does not, it stays
> Vary On Pending... All other devices are ok.
>  Any ideas or is this not possible?
>
>
> I have double and triple checked addresses, they are ok.  Have swapped
> network cables with ones I know work and same result. Swapped baluns
> with ones I know work, no diff....
>
>
>
> Mark Allen
> Director of MIS
> Fast Friends, Inc.
> (601) 888-4392 ext. 13
> www.fast-friends.com
>
>

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---