Re: Problem with command: WRKUSRJOBQ

Folks, this was a mistake in my part. Upon further investigation, this
command was written at the company. I hope no one wasted any time on this.

Thanks,
Phil
----- Original Message -----
From: <pike4@ix.netcom.com>
To: <MIDRANGE-L@midrange.com>
Sent: Wednesday, August 09, 2000 11:04 AM
Subject: Problem with command: WRKUSRJOBQ


>
> When using this command, if you take a *YES for the 'Allow Changes'
option, it allows you to type a '2' there, and then brings up a screen that
is headed CHGJOB. However, it is a modified version of CHGJOB, with out the
ability to change the job q, for example. Is there a switch somewhere that
would give you the full CHGJOB parameters?
>
> Thanks,
>
> Phil Kestenbaum
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
david@midrange.com
> +---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---