RE: Table saw shake

Sooooooooo? What OS is the table saw on, is it Y2K ready? And, did the table
vibration cause the excitment?

Dale Draper
Sega Enterprises, Inc. (USA)
Dale.Draper@seu.sega.com
415-701-6555


> -----Original Message-----
> From: Pat Barber [SMTP:MBOCEANSIDE@postoffice.worldnet.att.net]
> Sent: Monday, July 26, 1999 1:49 PM
> To:   MIDRANGE-L@midrange.com
> Subject:      Table saw shake
> 
> I forgot to mention, in all my excitement this morning, the table
> saw vibration went away with a belt change and reinstalling motor
> on saw(per installation instructions)... My old belt looked fine,
> but apparently developed a "set" from lack of use in all of the recent
> heat wave(which keeps me away from saw). I also did minor tune up of
> fence and guard/splitter.. I also went out and purchased a new
> Freud LU87 24 tooth thin kerf rip blade, which made a WORLD of
> difference
> in ripping that nasty old pressure treated 2x10's etc,etc.... I
> thought all the hoopla about thin kerfs was just that , HOOPLA, but
> no indeed, they do make a huge difference...
> 
> I also ordered a set of machined pullys and a link belt, which ought to
> help out quite a bit <>>><>><><><>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to
> MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
> david@midrange.com
> +---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---