Re: Call remote AS/400 program

There are a couple of ways to do this:
You can configure DDM and use the SBMRMTCMD command, or the SBMRMTJOB command.

If you have TCP/IP active betwee the boxes you can use FTP's remote Command
(REXEC) function.

You can also do it from Client Access useing remote command.  This is a DDM
function but does not require that you configure anything.

jte


S.A. Centea wrote:

> Where can I find some info about calling from a host
> AS/400 system a program on a target remote AS/400
> system ?
>
> Thanks
>
> ===
> Andrei Centea
> Canadelle Inc - Sara Lee Corp.
> Montreal
> _________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.com address at http://mail.yahoo.com
>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---



--
John Earl                                              johnearl@toolnet.com
PowerTech Toolworks                         206-575-0711
PowerLock Network Security              www.400security.com
The 400 School                                    www.400school.com
--


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---