Hi all,
I have just obtained my 9402-model 200--slight problem is that I have no
idea how to
get to manual mode and do a powerdown from the AS/400 panel.
how did I get myself in this sorry state.
1:attached good working 3197 terminal set at address 0(tested just before
on my trusty E20) into port0 of model 200--made sure of 01 B N(for normal)
on AS/400 panel and powered on--when terminal changed from 1/80 to 1/2 with
system status light bottom left hand corner;
I assumed all ok-since this is usual during a IPL--went away for 40 min.
Upon arrival noticed no signon screen-terminal still at 1/2 and system
status light on,
AS/400 panel shows normal 01 B so I assume must of IPLed OK.
Retested 3197 terminal on my E20-all OK and put back into model 200-no
change.
Q1:Any clues as to what is going on?
Q2:I need to go to manual mode and hit the powerdown button--no idea how to
get there--the model200 does not take a key like the E20-it has a uparrow
button,down arrow button and a enterkey?
Q3:Aboubt 12months ago I found a usermanual for the model 200 on IBMs
site--cant remember how I got there--any clues?
thanks in advance
Dave B
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---
