Re: Code/400 and VA/RPG v3r2r2 beta

Joe, is the tcp server address configured on the PC?  Right near where you 
start the code daemon there is another place where you have to tell Code what 
server it should try to connect to.  (yes, Code does RPG as well as RPGLE and 
CL.  O-specs are there, with the help and prompting.  I am told there is also 
an easy way to do dds for a printer output layout but that i haven't been able 
to figure out yet.)    


In <003b01be8166$f2e82520$cfa984a9@joesdt>, on 04/07/99 
   at 09:24 PM, "Joe Teff" <jteff19@idt.net> said:

>I sent the following message to <varpg@ca.ibm.com> last week. I have not
>received a response, so I will try list .
>----------------------------------------------------------------------------
>----------------------
>I downloaded the new beta for VA/RPG and CODE. It installed
>without any problems. I started TCPIP Communication Server. I then
>started a ClientAccess session and issued the STRCODE command with OS400
>as the server, my IP address and *TCPIP
>as the communications method. I received

>EVF4023E - CODE Daemon

>Unable to exchange CODE signature with host 'xxx.xxx.xxx.xxx'. The
>exchange failed due to a TCP/IP error - No data was received. The error
>is probably caused by the fact that you have not installed the back-end
>fix for CODE communications.
>Please install one of the following fixes and refer to the README for
>SP05.
>   V3R2M0:                        5763PW1   SF49534
>   V3R7M0, V4R1M0:      5716PW1   SF49524
>   V4R2M0:                        5769PW1   SF49535

>We are running V4R2 and have PTF SF49535 loaded. I had the beta I
>received at the 1998 Spring COMMON loaded on, but removed that before I
>installed this. I didn't use that beta much, but the couple of times I
>did use it, I was able to connect to the AS/400 without any problems.

>Also - can the designer work on O-specs located in RPG source code?

>Thanks,
>Joe Teff

>+---
>| This is the Midrange System Mailing List!
>| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
>| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
>| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
>| Questions should be directed to the list owner/operator: david@midrange.com
>+---


-- 
-----------------------------------------------------------
boothm@ibm.net
Booth Martin
-----------------------------------------------------------

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---