Re: Weirdo Twinax Address Problem

Jeff,

        What type system do you have, and what names are assigned to the
workstation controllers.   Some of the 6xx systems supported a finite number
of connections on WSC 1, (28 I think), and then 40 on WSC 2 - n to the
system max.   What you are calling port 7 could be on WSC 2 and Port 0 would
be on WSC 1 which could be full.

        Jeff Silberberg...

-----Original Message-----
From: Jeff Crosby <jlcrosby@fwi.com>
To: MIDRANGE-L@midrange.com <MIDRANGE-L@midrange.com>
Date: Wednesday, February 24, 1999 2:41 PM
Subject: Re: Weirdo Twinax Address Problem


>eric.delong@pmsi-services.com wrote:
>
>>      Do your printer devices have a termination switch which need to be
>>      set? Remember that only the last device on the port should be
>>      terminated. Also check the cable used to connect from Anzac 3017 to
>>      the IBM 6400.
>
>The cables are OK, and the switches are all set correctly.  :(
>
>--
>-Jeff
>
>jlcrosby@fwi.com
>+---
>| This is the Midrange System Mailing List!
>| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
>| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
>| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
>| Questions should be directed to the list owner/operator:
david@midrange.com
>+---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---