Re: RAID question

Jeff,

Under SST, Option 3. Works with disk units, Option 1. Display disk 
configuration,
Option 3. Display disk configuration protection, what does it show ?

Chuck

Jeff Carey wrote:

> We just added 2 drives to an S20 that previously had 4 drives on it (one
> RAID set).  I used SST to add the new drives to device parity protection
> and then added them to my ASP.  As we were not adding a full RAID set, I
> expected the system to mirror the devices.  Instead, I see this on the
> WRKDSKSTS display:
>
>                     --Protection--            --Protected--
> Unit      ASP       Type      Status          Size
> 1         1    DPY       ACTIVE          3145
> 2         1    DPY       ACTIVE          3145
> 3         1    DPY       ACTIVE          3145
> 4         1    DPY       ACTIVE          3145
> 5         1    DPY       ACTIVE          4194
> 6         1    DPY       ACTIVE          4194
>
> This gives more DASD than if the new drives were irrored, but are they
> really protected?  If so, why am I seeing all 4194 MB?
> We are at V4R1.
>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---