× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.



Buck,

In some async programs I wrote about 6-7 years ago I used the TIMER 
option before the INVITE, then checked for a '0310' in Major/Minor 
code, also at that time in RPG only it would not update the MAJ/MIN 
code correctly and the circumvention was to check the *STATUS  for 
'01331'.  They were suppose to fix this, but you never know, it took 
six month's for them to find the problem and admit it.  Maybe other 
errors have cropped in since then!

Good luck

-- Jim Lowary


> This week's question is for the communications programmers.
> I have an async program that does an invite, then a read.
> The WAITRCD is set to 15 seconds, and works most of the 
> time.  The situation where it doesn't work is when I 
> have lots of parity errors on the line.  What happens is...
> nothing.  The line, controller and device all show ACTIVE
> but the READ doesn't time out.  If I cancel the job, the
> controller and device go to FAILED.  If I vary the line, 
> ect. off and on and re-start the job, everything works fine 
> until the parity errors pile up again.
  


  |
  |
  ||  /|
  | |/ |
  |    |
  |    |
  | /| |
  |/ | |          SYNAPSE Communications, Inc.
 ____|_|  _          http://www.synapse.com
(_______)| \
(_______)|  )----------------------------------------
(_______)|  )----------------------------------------
 (______)|_/    
     | |        Tech-Support: (800) 457-5250  
     | |                 BBS: (573) 886-0738 
     | |               
      ||                  office@synapse.com 
      ||                    
      ||
       |
       |
       

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to "MIDRANGE-L@midrange.com".
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---


As an Amazon Associate we earn from qualifying purchases.

This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.