Re: CA/400 for NT - File Transfer Woes

At 06:55 PM 8/14/97 -0500, you wrote:
>
>I am now in the alligator pit that is the CA/400 95/NT software package.
I have a Pentium 802.2 connected to a 400 running 3.2 over CA/400 3.1.2
Service Pack 4xxx.  When trying to do a file transfer (specifically to the
PC) the job log for the transfer job contains PWS0008 - The OS/400 database
server cannot be run.   CAUSE: Stream fetch is only supported through the
Qserver Subsystem.
>
>I have to end the transfer job on the 400; hitting cancel on the PC side
does nothing (interesting that it still uses 400 resources).
>
>I have went through IBM's documents and the only mention for this message
describes problems with Microsoft's SNA and TCP/IP.  The basic problem
being that the Host Server database daemon is not running or not running in
Qserver.  I have checked the joblog for job QZDASRVSD which is generated by
a ENDHOSTSVR *DATABASE and it indicates that it was running in Qserver.  So
the 400 side would seem to be fine.  The job log for the PC transfer job
shows it was running in Qsnads (this must be the problem).
>
>Anyone have any bright ideas?
>
>Bill Robins

Have you run STRHOSTSVR *ALL on the 400? This is recommended for any file
service functions.


Vernon Hamberg
System Software Programmer
Old Republic National Title Insurance Company
400 Second Avenue South
Minneapolis, MN 55401
(612) 371-1111 x480
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This is the Midrange System Mailing List!  To submit a new message,   *
* send your mail to "MIDRANGE-L@midrange.com".  To unsubscribe from     *
* this list send email to MAJORDOMO@midrange.com and specify            *
* 'unsubscribe MIDRANGE-L' in the body of your message.  Questions      *
* should be directed to the list owner / operator: david@midrange.com   *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *