Re: ECS Line/Modem problem

Whibley,Dik wrote:
> 
> From: WHIBLERM at ENGPO1 1997/06/17 09:16
> Receipt Requested:
> Subject: ECS Line/Modem problem
> To: LMS1.OAS at ENGLINK
> -------------------------------- Message Contents
> ------------------------------
> 
>      I wish to replace our IBM 5858-01 modems running at 2400 with
> modems
>      running at 9600 on the ECS lines of both AS/400's (Model 300 &
> 310).
> 
>      I have purchased two Hayes Optima 336 Business Modems which are
>      synchronous capable.
> 
>      I have changed the line speed and link speed parameters on the
> Line
>      Description to 9600.
> 
>      When I run SNDSRVRQS *TEST I receive message
>      CPA5902 Controller QESCTL not contacted. Call out request failed.
> 
>      Can anyone point me to where I am going wrong?


To start you need to dig deeper for more error message detail.
Was there additional help text on this message ?
Check joblog for messages that may have been issued prior to this
message.
Do DSPLOG QHST and look for any messages there.

You have a setup problem with the modem and the additional detail should
point you in the right direction.

Most likely settings you don't have correct:
DSR (107) On ...CONNECT
RFS (106) On ...V.25 Bis
(and of course, modem set to Synchronous Switched mode).   :-)


The line speed parameters for line QESLINE don't really make any
difference.  They are used only be performance monitor to calculate
percentage of line utilization.


-- 
... Neil Palmer                                      AS/400~~~~~      
... NxTrend Technology -Canada       ____________          ___  ~     
... Markham,  Ontario,  Canada       |OOOOOOOOOO| ________  o|__||=   
... Phone: (905) 731-9000 x238       |__________|_|______|_|______)   
... url:http://www.NxTrend.com        oo      oo   oo  oo   OOOo=o\   
... mailto:NPalmer@NxTrend.com     ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This is the Midrange System Mailing List!  To submit a new message,   *
* send your mail to "MIDRANGE-L@midrange.com".  To unsubscribe from     *
* this list send email to MAJORDOMO@midrange.com and specify            *
* 'unsubscribe MIDRANGE-L' in the body of your message.  Questions      *
* should be directed to the list owner / operator: david@midrange.com   *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *