Re: using order policy code B

The re-order report should have the created requisition listed. MAPICS does not 
print a "requisition" similar to a PO.

You then must go to the requisition (either with green screen or browser) and 
create the PO.

--
Best regards,

Mike Dreimiller
Mandis Inc.
410-526-5996
Mandis-Inc@xxxxxxx

 -------------- Original message ----------------------
From: "Stage Logistiek" <stagelog@xxxxxxxxxxxxxxxxx>
> Again some questions in using Order policy Code B.
> auto release code = 1 (auto release requisition)
> 
> available= 39
> on-hand = 53
> so: allocated= 14
> 
> order point = 100
> 
> (so in my point of view there should be a requisition)
> 
> Then I run the Reorder Report in Inventory Management:
> 
> the print parameters have been set on 1;
> auto release of requisition = 1
> auto release of P.O= 1
> 
> After running the Reorder Report in Inventory Management, I see no 
> Requistions 
> or Purchase Orders. 
> 
> Although the print parameters have been set on 1, my printer isn't printing, 
> there are even no print jobs. 
> 
> 
> Kind regards,
> 
> Arno de Bliek
> _______________________________________________
> This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
> To post a message email: MAPICS-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/mapics-l
> or email: MAPICS-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/mapics-l.
>