RE: Can't Start KBC Dialogue in COM

This message is in MIME format. Since your mail reader does not understand
this format, some or all of this message may not be legible.
--
[ Picked text/plain from multipart/alternative ]
Thanks!

That was it.


_________________________________
Kevin Baltus - Programmer/Analyst
Gross Given Manufacturing /
Automatic Products International
St. Paul, Minnesota USA

kbaltus@automaticproducts.com
651.290.6179 (phone)
651.224.5559 (fax)
www.automaticproducts.com

personal site: www.kevinbaltus.com

-----Original Message-----
From: Chris Caparon [mailto:chris@crimson-software.com]
Sent: Wednesday, January 30, 2002 3:23 PM
To: mapics-l@midrange.com
Subject: RE: Can't Start KBC Dialogue in COM


Kevin,

The flag for a KBC item is set in the Item extension file in COM.  When you
copied the families over, the extension file flag was not set.  If you do
not want to DFU the file, edit the family name in KBC file maintenance and
then update the record.  That will reset the flag in the extension file and
you should be fine.  You do not have to change anything in the record.  The
update process is what cleans everything up.

Regards,

Chris Caparon
Crimson Software Technologies
909-624-3627 - Office
909-560-1909 - Cell
909-498-7349 - Fax
www.crimson-software.com


-----Original Message-----
From: mapics-l-admin@midrange.com [mailto:mapics-l-admin@midrange.com]On
Behalf Of Baltus, Kevin
Sent: Wednesday, January 30, 2002 1:12 PM
To: 'mapics-l@midrange.com'
Subject: Can't Start KBC Dialogue in COM

This message is in MIME format. Since your mail reader does not understand
this format, some or all of this message may not be legible.
--
[ Picked text/plain from multipart/alternative ]
Hi,

After copying entire families and questions from one environment to another,
ran the Knowledge Base Load.  Then did a KBC evaluation to make sure the
dialogue runs smoothly, etc.

Once things looked OK, next step was to enter a test order.  Usually after
entering the end-item the dialogue begins.  However it's not for the new
end-item we're testing out.

It seems we're missing a very small piece/switch of some sort.

Thanks in advance for any impute you may have!


_________________________________
Kevin Baltus - Programmer/Analyst
Gross Given Manufacturing /
Automatic Products International
St. Paul, Minnesota USA

kbaltus@automaticproducts.com
651.290.6179 (phone)
651.224.5559 (fax)
www.automaticproducts.com

personal site: www.kevinbaltus.com
_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/mapics-l
or email: MAPICS-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mapics-l.

_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/mapics-l
or email: MAPICS-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mapics-l.