Re: Domino server not starting

Thanks, Keith. We are able to ENDDOMSVR *IMMED, so our plan right now is
to do that and then IPL overnight. 

Lotus Domino on the iSeries / AS400 <domino400@xxxxxxxxxxxx> writes:
>Michael,
>
>We have had this happen a couple of time (Domino R6.5 on v5r2) with the 
>following results...
>
>1) Try to end the Domino server with the ENDDOMSVR command, if that fails,
>2) Attempt to end the Domino server with the ENDDOMSVR command and
>specify 
>the OPTION(*IMMED) option, if that fails,
>3) Attempt to end the subsystem running Domino with the ENDSBS command,
>if 
>that fails,
>4) Attempt to end the subsystem running Domino with the ENDSBS command
>and 
>specify the OPTION(*IMMED) option.
>
>On occasion, if these 4 options do not properly shut down the Domino 
>server, you may need to IPL the system.  We spent a good bit of time with 
>an IBM support tech trying to figure out why it would hang up so bad that 
>we could not even end the subsystem.  BTW, if you cannot end the 
>subsystem, you will most likely not be able to power down the system 
>controlled, but instead need to execute a PWRDWNSYS OPTION(*IMMED).
>
>I know this may sound a bit extreme, but it only reflects our experience.
>
>Good Luck.



Mike Naughton
Senior Programmer/Analyst
Judd Wire, Inc.
124 Turnpike Road
Turners Falls, MA  01376
413-863-4357 x444
mnaughton@xxxxxxxxxxxx