Re: Compiling a C++ program on the AS/400

Hello Mike,

You wrote:
> Before I begin writing a C++ program, I want to make
> sure the AS/400 Create Program command will compile a
> C++ program. 

It depends on what you mean.  If you mean CRTPGM then you have to get the C++ 
source 
into a form understood by CRTPGM.  If you mean CRTCMOD or CRTBNDC then no, it 
doesn't 
understand C++.

However there are two approaches.  There is a C++ PRPQ called 5799GDW which is 
an AS/400 
C++ compiler.  There is also a PC-based cross compiler.  (and work is 
progressing on an 
extremely angry compiler especially for me :)

Regards,
Simon Coulter.

«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»
«» FlyByNight Software         AS/400 Technical Specialists       «»
«» Eclipse the competition - run your business on an IBM AS/400.  «»
«»                                                                «»
«» Phone: +61 3 9419 0175      Mobile: +61 0411 091 400           «»
«» Fax:   +61 3 9419 0175      mailto: shc@flybynight.com.au      «»
«»                                                                «»
«» Windoze should not be open at Warp speed.                      «»
«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»«»

+---
| This is the C/400 Mailing List!
| To submit a new message, send your mail to C400-L@midrange.com.
| To subscribe to this list send email to C400-L-SUB@midrange.com.
| To unsubscribe from this list send email to C400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: bob@cstoneindy.com
+---